MIL-DTL-22499 Shim Stock, Laminated \(S/S By Sae-Ams-Dtl-22499\)

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11

MIL-DTL-22499D

4.3.2 Peel strength. Peel strength shall be tested in accordance with ASTM D 903 (see 3.2.2). The number

of peels per sample shall be in accordance with Table III.

4.3.3 Water immersion. Representative strips of the sample shim stock specified in 4.3.1 shall be

immersed in water at 120�F � 5�F for a period of 3 hours. At the end of the test period, the shim stock shall be

examined to determine compliance with the requirements of 3.4.

4.4 Quality conformance inspection

4.4.1 Lot. A lot shall consist of all of the shim stock of the same composition, type, class, nominal size

and lateral dimensions, manufactured under essentially the same conditions, and submitted for acceptance at the

same time.

4.4.2 Samples. Statistical sampling and inspection shall be in accordance with the general requirements of

ANSI/ASQC Z1.4. Lot acceptance criteria shall be based on a single sampling plan with a zero acceptance number.

4.4.3 Examination. The sample shim stock, selected in accordance with 4.4.2, shall be visually and

dimensionally examined to determine compliance with the requirements of this specification.

4.4.4 Inspection of material. The material used in the manufacture of the laminated shim stock furnished

under this inspection shall have been inspected and accepted in accordance with the respective specifications

specified herein. The contractor shall furnish certification that the above requirements have been met.

5. PACKAGING

5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the contract

or purchase order (see 6.2). When actual packaging of material is to be performed by DoD personnel, these

personnel need to contact the responsible packaging activity to ascertain requisite packaging requirements.

Packaging requirements are maintained by the Inventory Control Point's packaging activity within the Military

Department or Defense Agency, or within the Military Department's System Command. Packaging data retrieval is

available from the managing Military Department's or Defense Agency's automated packaging files, CD-ROM

products, or by contacting the responsible packaging activity.

6. NOTES

6.1 Intended use. The surface laminated shim stock covered by this specification is intended for use in the

manufacturing of laminated shims. Note: Edge bonded shims shall comply to composition, type and class only.

Surface laminated construction does not apply to edge bonded shims.

6.2 Acquisition Requirements. Acquisition documents shall specify the following:

a. Title, number and date of this specification and specification sheets as applicable.

b. Composition/specification of laminate, temper or condition of material and either: type, class and

nominal size (see 1.2, 3.2.1, and 3.3); or part number selected from the applicable specification

sheet.

c. Dimensions of shim stock (see 3.3).

d. Quantity.

e. Packaging requirements (see 5.1).

f. Whether first article is required ( see 3.1 and 6.3).

g. Sampling plan (see 4.4.1 and 4.4.2).

-6-