MIL-DTL-46063H
APPENDIX A
ARMOR PLATE, ALUMINUM ALLOY, 7039
A.1
SCOPE
A.1.1 Scope. This appendix covers the minimum ballistic limits for
acceptable requirements of aluminum alloy armor plate, 7039 when tested in
accordance with the provisions of this specification. When there is mutual
agreement between contractor and procuring activity, this appendix becomes a
mandatory part of this specification and the information contained herein is
intended for compliance.
A.2
APPLICABLE DOCUMENTS
A.2.1
Government documents.
A.2.1.1 Specifications, standards, and handbooks. The following
specifications, standards, and handbooks form a part of this document to the extent
specified herein. Unless otherwise specified, the issues of these documents are
those listed in the issue of the Department of Defense Index of Specifications and
Standards (DoDISS) and supplement thereto, cited in the solicitation (see 6.2).
STANDARDS
DEPARTMENT OF DEFENSE
MIL-STD-662 - V50 Ballistic Test For Armor
(Unless otherwise indicated, copies of the above specifications, standards, and
handbooks are available from the Defense Automated Printing Service (DAPS),
Bldg. 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094.)
A.3
DEFINITIONS
A.3.1 Complete penetration, (CP). A complete penetration occurs when the
impacting projectile, or any fragment thereof, or any fragment of the test
specimen perforates the witness plate, resulting in a crack or hole which
permits light passage when a 60-watt, 110-volt bulb is placed proximate to the
witness plate.
A.3.2 Fair impact. An impact should be considered fair when an unyawed
fragment simulator or test projectile strikes an unsupported area of the target
material at a specified obliquity at a distance of at least two projectile
diameters from any previous impact or disturbed area resulting from an impact,
or from any crack, or from any edge of the test specimen.
A.3.3 Gap. A gap is the difference in fps between the high partial
penetration velocity and the low complete penetration velocity used to compute
the ballistic limit when the high partial penetration velocity is lower than the
low complete penetration velocity.
A.3.4 Partial penetration, (PP). Any impact which is not a complete
penetration should be considered a partial penetration.
A.3.5 Witness plate. A thin sheet located behind and parallel to the
ballistic test sample which is used to detect penetrating projectiles or spall.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business