MIL-DTL-46077G
(Copies of this document are available from www.asq.org or American Society for Quality
Control, 600 Plankinton Avenue, Milwaukee, WI 53203.)
ASME INTERNATIONAL
SAE-AMS 2249
-
Chemical Check Analysis Limits - Titanium and Titanium
Alloys (DoD Adopted)
SAE-ARP 982
-
Wrought Titanium Alloy Products, Minimizing Stress
Corrosion Cracking in (DoD Adopted)
(Copies of this document are available from www.asme.org or ASME International, Three Park
Avenue, New York, NY 10016-5990)
ASTM INTERNATIONAL
ASTM A480/A480M
-
Standard Specification for General Requirements for Flat-
Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and
Strip (DoD Adopted)
ASTM E8
-
Standard Test Methods for Tension Testing of Metallic
Materials, (DoD Adopted)
ASTM E120
-
Chemical Analysis of Titanium and Titanium-Base Alloys
(DoD Adopted)
ASTM E539 `
-
Standard Test Method for X-Ray Emission Spectrometric
Analysis of 6Al-4V Titanium Alloy
ASTM E1409
-
Standard Test Method for Determination of Oxygen and
Nitrogen in Titanium and Titanium Alloys by the Inert Gas
Fusion Technique
ASTM E1447
-
Standard Test Method for Determination of Hydrogen in
Titanium and Titanium Alloys by Inert Gas Fusion Thermal
Conductivity/Infrared Detection Method
(Copies of these documents are available from www.astm.org or ASTM International, 100 Barr
Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein, the text of this document takes precedence. Nothing in this document,
however, supersedes applicable laws and regulations unless a specific exemption has been
obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), the contractor shall furnish a sample or samples for
first article inspection and approval. The contractor shall comply with this requirement at the
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business