MIL-DTL-46192C(MR)
4.9.1.1 Retests. Resubmission of first article samples shall not be made until
the manufacturer has made necessary corrections in the processing of the
material to the satisfaction of the procuring activity. Samples submitted for
retest shall be marked R1, R2 and R3, if applicable, in addition to the
requirements of 3.8.
4.9.2
Acceptance.
4.9.2.1 Examination. A quality conformance lot shall be rejected for failure
to meet the visual, dimensional and preparation for delivery requirements when
examined in accordance with 4.8.
4.9.2.2 Tests. A quality conformance lot shall be rejected for failure to meet
any of the requirements of any of the tests outlined in 4.3.2.
4.9.2.3
Retests.
4.9.2.3.1 Chemical composition and mechanical properties. Retests shall be
conducted in accordance with the methods specified in 4.7.1 and 4.7.2.
4.9.2.3.2 Stress corrosion (first article) testing only. If the manufacturer
so desires, a retest shall be performed using three additional specimens. No
cracking shall occur in 10 days. If the retest also fails, the manufacturer may
elect to resubmit the lot after retreatment of the entire lot. After
retreatment, the lot must conform to the requirements outlined in 3.5.
4.9.2.3.3 Ballistic. Rejection and retest of ballistic test plates shall be in
accordance with A.5.2.
4.9.2.4 Reduced testing. At the discretion of the procuring activity, the
amount of testing may be reduced provided the results on consecutive lots
indicate that a uniform product, meeting the testing requirements is being
produced and provided the manufacturer agrees to maintain the same manufacturing
procedures.
5.
PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be
as specified in the contract or order (see 6.2). When actual packaging of
materiel is to be performed by DoD personnel, these personnel need to contact
the responsible packaging activity to ascertain requisite packaging
requirements. Packaging requirements are maintained by the Inventory Control
Point's packaging activity within the Military Department or Defense Agency, or
within the Military Department's System Command. Packaging data retrieval is
available from the managing Military Department's or Defense Agency's automated
packaging files, CD-ROM products, or by contacting the responsible packaging
activity.
6.
NOTES
(This section contains information of a general or explanatory nature that may
be helpful, but is not mandatory.)
6.1
Intended use.
The material specified herein is for military vehicles.
- 10 -
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business