MIL-DTL-46192C(MR)
1251
Optical Emission Spectrometric Analysis of Aluminum and
Aluminum Alloys by Argon Atmosphere, Point to Plane, Unipolar
Self-initiating Capacitor Discharge Chemical Analysis
G47
Determining Susceptibility to Stress-Corrosion Cracking of
High Strength Aluminum Alloy Products
(Application for copies should be addressed to the American Society for Testing
and Materials, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959).
2.4 Order of precedence. In the event of a conflict between the text of this
document and the references cited herein, the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and
regulations unless a specific exemption has been obtained.
3.
REQUIREMENTS
3.1 First article. When specified in the contract or purchase order (see 6.2)
and before production has commenced, samples of the specified item shall be made
available to the contracting officer or his authorized representative for
approval in accordance with 4.3.1. The approval of the first article samples
authorizes the commencement of production but does not relieve the supplier of
responsibility for compliance with all applicable provisions of this
specification. The first article samples shall be manufactured by the process
proposed for use on production.
3.2 Chemical composition. Chemical composition of material furnished under
this specification shall be within the limits specified in table I (see 6.2).
3.3 Mechanical properties. Unless otherwise specified in the contract or order
(see 6.2), the mechanical properties of rolled plate shall meet the requirements
of table II, when tested as specified in 4.7.2.
3.3.1 If mechanical property requirements differ from the values shown in table
II, or if any other properties are required, the ballistic requirements shall be
as agreed upon between the procuring activity and the manufacturer.
3.4 Ballistic requirements. Each ballistic test plate shall be proof fired for
resistance to penetration by determining a protection ballistic limit, BL(P)
(see 6.2). The BL(P) shall be as specified in appendix A.
-3-
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business